# Control Signals Generation using Counter

- In various digital applications(For example : hardwired control unit) control signals are needed to start, execute and step various operations in a particular time sequence.
- For this control signals are required and for the generation of control signals, a counter circuit is designed whose outputs are connected to a decoder. The decoder provides the required control signal.
- The counter can be synchronous or asynchronous.
- The procedure for designing the counter is the same refer (this).

The design of control signal can be understood by considering the example.**Example – **Generate a control signal which can deliver the following pulse train. The pulse train will repeat after 7 pulses.

Here we need to generate a control signal (say S) which can generate periodic pulse train of **0111001** and then repeats. The pulse train repeats after 7 seven pulses. Therefore,** mod -7 counter is needed.** The outputs of Mod-7 counter will be connected to a decoder circuit. For this a mod –7 counter is to be designed. Three T flips are required(because we need to count up to 000 to 110, therefore 3 bits are needed).

For the design for Mod — N counter please refer this article.

**Design for mod-7 counter – **

Here Q is previous state and Q* is next state.

The expressions for inputs of T flip-flops obtained from the K – maps shown below.

The truth table for the** decoder is obtained by observing of the given timing sequence(0111001**). The simplified expression for the output S of decoder is obtained using the K-map. The not used counts are considered as don’t care.

Each counting sequence is mapped to one control signal bit.

The combinational logic of decoder can be found by solving K map.

Simplified expression for decoder circuit is S= Q_{1}+ Q’_{2}Q_{0}.**Example —** When we are in state Q_{2} =0 Q_{1}= 0 Q_{0} = 0, then the value of S = 0+0.1= 0.

The decoder circuit generates output after every clock(-ve edge triggered) pulse. The output i.e S will be act as Control signal for other circuitry.

The generation of a control signal takes place after each negative edge clock and timing diagram for such control signal may also be drawn as shown below. Each counter state is used for generating one control signal.