Skip to content
Related Articles
Open in App
Not now

Related Articles

8086 program to determine largest number in an array of n numbers

Improve Article
Save Article
  • Difficulty Level : Hard
  • Last Updated : 22 May, 2018
Improve Article
Save Article

Problem – Write a program in 8086 microprocessor to find out the largest among 8-bit n numbers, where size ā€œnā€ is stored at memory address 2000 : 500 and the numbers are stored from memory address 2000 : 501 and store the result (largest number) into memory address 2000 : 600.

Example –

Algorithm –

  1. Load data from offset 500 to register CL and set register CH to 00 (for count).
  2. Load first number(value) from next offset (i.e 501) to register AL and decrease count by 1.
  3. Now compare value of register AL from data(value) at next offset, if that data is greater than value of register AL then update value of register AL to that data else no change, and increase offset value for next comparison and decrease count by 1 and continue this till count (value of register CX) becomes 0.
  4. Store the result (value of register AL ) to memory address 2000 : 600.

Program –

400 MOV SI, 500 SI<-500
403 MOV CL, [SI] CL<-[SI]
405 MOV CH, 00 CH<-00
407 INC SI SI<-SI+1
408 MOV AL, [SI] AL<-[SI]
40D CMP AL, [SI] AL-[SI]
40F JNC 413 JUMP TO 413 IF CY=0
411 MOV AL, [SI] AL<-[SI]
413 INC SI SI<-SI+1
414 LOOP 40D CX<-CX-1 & JUMP TO 40D IF CX NOT 0
416 MOV [600], AL AL->[600]

Explanation –

  1. MOV SI, 500 : set the value of SI to 500
  2. MOV CL, [SI] : load data from offset SI to register CL
  3. MOV CH, 00 : set value of register CH to 00
  4. INC SI : increase value of SI by 1.
  5. MOV AL, [SI] : load value from offset SI to register AL
  6. DEC CL : decrease value of register CL by 1
  7. INC SI : increase value of SI by 1
  8. CMP AL, [SI] : compares value of register AL and [SI] (AL-[SI])
  9. JNC 413 : jump to address 413 if carry not generated
  10. MOV AL, [SI] : transfer data at offset SI to register AL
  11. INC SI : increase value of SI by 1
  12. LOOP 40C : decrease value of register CX by 1 and jump to address 40D if value of register CX is not zero
  13. MOV [600], AL : store the value of register AL to offset 600
  14. HLT : stop
My Personal Notes arrow_drop_up
Related Articles

Start Your Coding Journey Now!